The role of the inf file is important as it forces windows to use the hdmi output as the default output. You'll find it is almost perfect, with maybe 2 pixels either side of the screen black. You'll find that it crops on the left hand side, so you need to nudge the picture to the right once. Do so and then go back to the display settings and apply the new resoultion. You hit Add New resoultion and it might ask you to restart. That bit can be a bit of a challenge! Now I have found that the best way of setting it up is by using the following settings: I'm sorry that I cannot help the OP myself since I work in the GTA.Well done on getting a picture up. All of the equipment feeding signals to the TV also needs to be optimized for audio and video. If you read the feedback in my link below on my optimization services, you'll see that everyone was pleased with a proper optimization.Īs alluded to in posts above, there's more to optimizing a home theatre than the TV. Follow the instructions in the FAQ link above and you'll almost always have a better picture. The reason it's so dark is so that the manufacturers can advertize low power consumption. This mode has the incorrect colour temperature and is now often not bright enough for most people. If you select "home", then you almost always get the "standard" mode. Since about 2010, many TVs now ask, when you first plug them in, if this is a home or store installation. Which was not too bad, but could still be improved upon.Ģ. These TVs almost always benefited from an optimization unless there was a "THX" or "Custom" mode. The "standard" mode had incorrect colour temperature, but not as bad as vivid. Most people however, did not like the "cinema/movie" mode because it was too dark. One could always then choose a different picture mode, with the farthest from "Vivid" usually being the most accurate. There was nothing good to say about that Vivid Setting. This mode was terrible - the colour temperature was way off, the sharpness was set way too high, the contrast was too high and black levels were all wrong. Between about 2000-2010, most TVs came preset to a very "vivid" mode.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |